Plastic Injection Moulding Machine
Screw diameter (mm) 45
Shot size (cubic centimeter) 350
Injection pressure (mpa) 170
Injection rate (g/s) 127
Screw l/d ratio (l/d) 22
Screw speed (r. P. M) 220
Clamping tonnage (kn) 1680
Toggle stroke (mm) 420
Mould height (mm) 150-500
Space between tie-bars (mm) 455*455
Ejector stroke (mm) 110
Ejector tonnage (kn) 35
Heat power (kw) 9.5
Pump motor power (kw) 15
Machine dimension (m) 5.0*1.4*1.9
Machine weight (ton) 5.2
Oil tank capacity (l) 380
Specifications:
1)adopt imported advanced hydraulic components.
2)adopt execellent control valves.
3)adopt imported PLC which is special for injection machine. It is processed and controlled
By CPU, improving the speed and the alarm on over-temperature.
4)oil motor drive the gear to adjust mould. The mould can be adjusted automatically
According to the pressure that was set up in anticipation.
The specifications of machine are listed below:
PLC(Panasonic in Japan)
Hydraulic system(yuken in Japan)
Controller(sumsung in hongkong)
Vane pump(American vickers)
Directional valve(American vickers)
Encoder(Germany)
Contactor(FUJI in Japan)
Air breaker(FUJI in Japan)
Thermo overload relay(FUJI in Japan)
Limit switch(omron in Japan)
Plastic Injection Moulding Machine offered by Zhejiang Lebao Plastics Equipment Factory